Rock-slide-engineering RAM STEP SLIDER Manual de usuario

Installation Instruction RSEI 108 Ram Step Slider Installation BD-SS-100-RAM, .BD-SS-101-RAM

Installation Instruction RSEI 108 a. Pull the rubber door seal away from near the latch and run the sensor wires u

Installation Instruction RSEI 108 THE BRASS COLORED PRONG IS FOR THE GROUND THE SILVER C

Installation Instruction RSEI 108 20. Position the actuating magnets on the catch side of each do

Installation Instruction RSEI 108 TROUBLE SHOOTING/FRICTION POINTS  The slider is powered by the truck’s battery when engine is off and power

Installation Instruction RSEI 108 PARTS LIST

Installation Instruction RSEI 108 1. Remove the black rubber pieces covering the factory mounting holes on the bottom and back of the cab pinch s

Installation Instruction RSEI 108 5. Hold the bracket up against the truck panel matching the body angles. Position the bracket so that the

Installation Instruction RSEI 108 8. Install the back bracket 9. Line up the bracket holes to the matching factory holes 10. Bolt the bra

Installation Instruction RSEI 108 16. Mak

Installation Instruction RSEI 108 20. Bolt the bottom of the bracket into the step slider body with a 7/16” bolt and washer. Tighten the bolt int

Installation Instruction RSEI 108 Step Slider Wiring Diagram Driver Side Wire Color Passenger Side Wire Color Front Door Sensor Oran

Installation Instruction RSEI 108 2. Lay out the wiring harness on the carpet in the back seat 3. Split the harne